Dynapac CS 141, Руководство по обслуживанию

Страница: 23 / 29

21
CS 141 M141EN4
EVERY 2000 HOURS OF OPERATION (Yearly)
Fig. 33 Hydraulic reservoir
1. Drain valve
2. Cover plate
3. Filler cap
4. Strainer
1
2
3, 4
Fig. 34 Fuel tank
1. Oil emptying pump
Fuel tank – Cleaning
1
Hydraulic reservoir
– Changing the fluid
Water tank – Cleaning
Fig. 35 Water tank
Clean the tanks with water and a suitable detergent for
plastic surfaces.
Refit the filter housing (1) or the drain plug (2), fill with
water and check for tightness.
The water tanks are made of recyclable
plastic (polyethylene).
It is easiest to clean the tank when it is almost empty.
Place a receptacle that will hold at least 50
liters (13 gallons) under the plug. Save the fuel
and dispose of it properly.
Remove the drain plug (1) and let all the fuel run out,
wipe and refit the drain plug.
Remember the danger of fire when hand-
ling fuel.
Place the roller on a level surface. Switch
the engine off and push in the reserve/
parking brake knob for all checking and
adjustments on the roller, unless otherwise
specified.
Danger of being burned when draining hot
oil. Protect your hands.
Place a receptacle that will hold at least 50
liters under the plug. Save the oil and dispose
of it in an approved manner.
Remove the drain plug (1) and allow all the oil to run out,
wipe and refit the drain plug.
Wash the filler cap (3) and the strainer (4) using a
cleaning agent and blow them dry.
Fill with fresh hydraulic fluid of the grade
indicated in the Lubricant specification.
Replace the hydraulic filter as described under the
heading ”Every 1000 hours of operation.”
Start the engine and operate the various hydraulic
functions. Check the level in the reservoir and top off as
required.
WARNING
CAUTION
WARNING
WARNING