Dynapac CC1250, Инструкция по эксплуатации

Страница: 67 / 74

Water Tank 3. Adjust the contact surface on both scraper
attachments.
Unscrew the tank cap and fill with clean water. Do
not remove the strainer. See technical
specifications for the tank volume.
4. Tighten all the screws after adjustment.
61 Maintenance
N o t e
A small amount of environment-
friendly antifreeze is added.
Figure 7-10: Water Tank
1 Tank cap
Fixed Scrapers
Make sure that the scrapers are undamaged.
Adjust the scrapers so that they are 1-2 mm from
the drum. For special asphalt compounds, it may
be better if the scraper blades lie lightly against
the drums.
Asphalt remnants can accumulate on the scraper
and affect the contact force. Clean as required.
1. Loosen the screws to adjust the contact
pressure of the scraper blade against the
drum.
2. Lock this setting by tightening the lock nut
against the mounting plate.
Figure 7-11: Drum
A Scraper blade
B Drum
The scrapers must be lifted from the drum during
transport.
Brakes
Run the roller very slowly forward. Hold the
steering wheel firmly and brace yourself for a
sudden stop. Press in the emergency stop. The
roller will stop abruptly and the engine will switch
off. After testing the brakes, set the forward/
reverse lever in neutral. Pull out the emergency
stop. Start the engine. The roller is now ready for
operation.