Dynapac CC1250, Инструкция по эксплуатации

Страница: 64 / 74

Batteries
The following battery maintenance must be
4. Remove and replace the oil filter.
Maintenance 58
Figure 7-5: Fuel Filters
A Fuel filter
B Engine oil filter
C Engine oil drain
5. Remove the oil filler cap and fill the engine
crank case with recommended oil.
6. Start the engine and allow it to idle for a few
minutes. During this time, check around the
oil filter and drain plug for leaks.
7. Install the oil filler cap.
carried out as part of the 200 hour routine
maintenance schedule.
Batteries contain an acid and can cause
injury. Skin and eye contact with battery
fluid can cause injury. Avoid skin and eye
contact with battery fluid. If contact
occurs, flush area immediately with
water.
Battery fumes can ignite and explode. Do
not smoke when observing battery fluid
level.
N o t e
When disconnecting the battery,
always disconnect the negative cable
first. When connecting the battery,
always connect the positive cable first.
Note
Always wear protective glasses when
working with batteries. Wash hands
after touching batteries and
connectors. Use of gloves
recommended.
Batteries, Clamps, and Cables
The standard batteries supplied are heavy duty
lead acid type, requiring the following
maintenance.
1. Keep the top of the batteries clean.
2. Clean the terminals.
3. Keep battery connections tight.
4. Apply a small amount of grease to the
terminal connections to prevent corrosion.
5. Inspect the cables, clamps, and hold down
brackets. Replace if necessary.
!
!