Dynapac CC1250, Инструкция по эксплуатации

Страница: 17 / 74

Operating Safety
Know the working area. Familiarize with work site
Driving Near Edges
While driving near an edge make sure to maintain
11 Safety First
obstructions and any other potential hazards in
the area.
Before Starting the Engine
• Inspect the roller for potential hazards.
• Adjust the rear view mirrors for good visibility.
• Make sure that the controls are in the neutral
position and the parking brake is applied.
• Make sure that there is no one in the immedi-
ate vicinity and there are no obstructions
around the machine.
Starting the Equipment
• Do not start the engine or move any of the
controls if there is a warning tag attached to
the controls. Check with the person who
attached the tag before starting.
• Read and follow all the instruction decals.
• Before starting the engine, check that all the
gear controls are in neutral position.
• Always inspect the motor before and after
starting.
• Check all the safety devices. Report any
defects immediately.
• Listen for unusual noises.
• Engage hydraulic controls slowly in cold
weather to avoid shock loading.
Parking the Roller
• Select the level and hard ground. If necessary
to park on the slope, block the front of the
drums on the downside of the slope.
• Apply break in an emergency conditions.
2/3 of the drum width on the solid ground.
Not e
The machine's center of gravity moves
outwards when steering. For example,
the center of gravity moves to the right
when you steer to the left.
Not e
Never operate machine on side
slopes. The machine may roll over,
even on stable ground. Always
operate the machine parallel to the
slope; never perpendicular.
Figure 2-1:Position of the Drum
Slopes
The slope angle is measured on a hard, flat
surface with the machine stationary. The steering
angle was zero, the vibration was switched OFF
and all tanks were full.