Dynapac CC1250, Инструкция по эксплуатации

Страница: 16 / 74

Safety First 10
Warnings and Cautions
Throughout the manual, Warnings, Cautions, and
Notes symbols are used to designate instructions
of particular importance. Look for these symbols
which point out items of extreme importance to
you and your co-workers’ safety. Read and
understand thoroughly. Heed the warning and
follow the associated instructions. In this manual,
these terms have the following significance:
WARNING ! Marks a danger or a
hazardous procedure that can result in
life threatening or serious injury if the
warning is ignored.
CAUTION ! Marks a danger or hazardous
procedure that can result in damage to
the machine or property if the warning is
ignored.
Note
Note is used for supplementary
information not directly effecting
safety or damage to equipment. Note
can also refer to special information on
the efficient use of the roller.
Modifications
The equipment is designed for safe operation. Do
not do anything that may hamper the safety
features or structural integrity of the equipment
Do not make any unauthorized modifications to
this equipment. Dynapac cannot be held
responsible for any accidents, incidents, or
damage to persons or property that are related to
the use of modified equipment.
Personnel Protective
Equipment
Anyone working around the roller must wear
approved safety equipment (safety shoes or
protective footwear, safety glasses, hearing
protection, hard hat, gloves, respirator, and the
like) when operating or maintaining the machine.
Wear close fitting clothing and confine long hair.
Operating requires full attention of the operator.
Do not wear radio or music headphones while
operating.
Tools and Equipment
Tools, lifting gear, fastening devices,
jacks, and other working equipment must
be in safe operational working
conditions.
Equipment or components which are
being fitted or removed or where their
installation position is being changed,
must be secured against unintentional
movement, slipping, or falling over. Use
suitable lifting gear or suspension/
support devices.
Systems and units (tensioning units)
must be depressurized in an appropriate
manner before opening.
Damaged hydraulic or mechanical pre-
tensioned spring elements must be
exchanged as a completed unit. Further
information can be found in the
respective component descriptions and/ or
fitting and removal instructions.
!
!
!
!
!
!