Dynapac CC1000 e, Инструкция по эксплуатации

Страница: 125 / 130

Maintenance - 2000h
4812164901_A.pdf 2022-11-14
Fig. Hydraulic reservoir
1. Sight glass
1
Check the hydraulic oil level in the sight glass (1) and
top off where necessary. See under the heading
‘Every 10 hours of operation’.
Hydraulic fluid filter - Change
Fig. Front frame, rear part
1. Hydraulic oil filter
1
Remove the filter (1) and recycle at your local
waste disposal station. This is a disposable filter
and cannot be cleaned. Remove the filter (1) and recycle at your local
waste disposal station. This is a disposable filter
and cannot be cleaned.
Thoroughly clean the filter holder sealing surface.
Apply a thin coat of fresh hydraulic fluid to the rubber
gasket on the new filter.
Screw the filter on by hand, firstly until the filter gasket
makes contact with the filter base. Then rotate a
further ½ turn.
Do not over-tighten. The seal can be damaged. Do not over-tighten. The seal can be damaged.
Release the parking brake to activate the hydraulics
and check that the filter is not leaking.
115