Dynamix IAD -162 Gateway
Step 2. Connect your PC to the LAN port of IAD
Connect your PC to the LAN port of Dynamix IAD - 162 with standard
CAT-5 straight Ethernet cable.
Step 3. Set your PC as DHCP mode
Please go to the network setting of your PC and set it as DHCP mode, let
your PC can automatically search for DHCP server and get one valid IP
address. IAD has embedded DHCP server (default is enabled) so that
your PC will get one IP address from IAD DHCP server.
Step 4.Open your browser and input IP address 192.168.123.123
Once your PC has got an IP from IAD, you may connect IAD via WEB
browser to do more configurations. The default LAN IP address of IAD is
“
192.168.123.123
”; please input this IP address on web browser to
connect with web management interface. Please refer to Part III Web
management for more information.
Step 5.Advanced Setting via Telnet (Optional)
If user wants to do more advanced and complete settings that cannot be
found via web management interface, please Telnet to the IAD to do
more detail configurations.
Step 6.Connect other PC with LAN Ports (Optional)
If you have more than one PC, you can connect them with LAN Ports
(black) on the IAD Gateway. Please set these PCs as DHCP mode so
that they can automatically get IP from IAD DHCP server. DHCP server
of IAD can assign 253 IP most.
Caution:
To prevent damage to the IAD Gateway, please make sure you have
connected with the correct power adapter.
2.1.3 Essential Configuration via Web Management interface
This section describes how to setup IAD via Web management interface. Please follow
procedures below to configure essential items before you use IAD gateway.
2.1.3.1 Save Data and Reboot
After any configuration has been made, user has to save all data and reboot system to
make configurations take effect.
Step 1.
Click [Commit Data] on the navigation panel. In the Commit Configuration
- 9 -
