Dynacord DPC 8015, Руководство пользователя

Страница: 12 / 56

Paging Console
12 Owner‘s Manual
higher priority signals, the TALK LED will vastly blink and the calling attempt is ignored (also refer to the
description of indications).
The TALK LED lights during the transmission of an announcement. The TALK button has to be pressed
during the whole message.
The TALK LED blinks when one or several areas are busy or when an event with higher priority setting
interrupts the output message (see paragraph indications). In the latter, it is necessary to repeat the
message.
Until the user makes any changes, the defined selection stays memorized, even after releasing the TALK
button. Pressing the ALL/CLEAR button two times de-selects the entire selection.
Collective Call
The announcement is launched into all areas of the entire installation.
The procedure is similar to making a selective call. First, all areas of the installation are selected by
pressing the ALL/CLEAR button. Pressing the TALK button activates the collective call. During the
transmission of a call, all area and/or group LEDs as well as the ALL LED will light (also refer to page 8).
The TALK button has to be pressed down until the end of the announcement. BUSY LED indication is
equivalent to the selective call.
General Alarm
A general alarm signal is always transmitted to all lines of the entire installation.
Pressing the covered ALARM button launches the integrated alarm. The button lights during the
transmission of the alarm signal. The alarm has priority over any announcement or other event, except for
those that were ignited from the directing paging station.
Pressing the STOP key cancels the alarm.
NOTE:
The launch of an alarm does not depend on a paging console’s priority setting it had
been activated from. Launching an alarm is possible from any microphone terminal at
any time, even when the system is in stand-by mode. A running alarm is optically and
occasionally also acoustically indicated at every paging station.