Dynacord DPC 8015, Руководство пользователя

Страница: 22 / 56

Paging Console
22 Owner‘s Manual
1. Disconnect paging console
2. Remove the paging console bottom plate (1)
3. Disconnect internal connection cord from connector CN1 (2)
4. Prepare mounting position (3) by break-through case from inside with a sharp tool (e.g. knife, scriber). If
required use a file/rasp to improve the cut-out.)
5. Adjust the switch and tighten it using the supplied milled nut.
6. Please refer to the circuit diagram on this page when connecting the
supplied 4-pole wire and the resistors.
7. Please mind the sequence in which you connect the flat wire cables.
The two outside wires 1 (rt) and 4 (gr) have to be cut off as short as
possible and need to be insulated. The two inner wires 2 (gr) and 3 (gr)
need to be soldered to contacts 1 and 2 of the switch. Polarity is not a
critical factor.
8. Afterwards, you have to connect the 4-pole female plug to the corre-
sponding CN201/CN202/CN203 terminal strip on the basic printed
board assembly.
9. Reconnect internal connection cord to connector CN1 (2)
10.Assemble the paging console bottom plate
11. Reconnect paging console
12.Configure switch using IRIS-Net PC software
4.5 Interface description
PCA BUS interface
The P ROMATRIX C AN A udio (PCA) BUS interface is used for connecting the DPC 8015 paging console
to the PROMATRIX 8000 system. The 8-pole RJ-45 connector provides power supply, control interface
(CAN bus), and audio connections. The microphone terminal has to be connected to a corresponding RJ-
45 wall outlet using the supplied connection cord (3 m). The following figure shows the pin-assignment of
PCA BUS socket and RJ-45 network cable.
NOTE:
Please make sure to solder the cables after the swich has been installed. Otherwise it is
virtually impossible to slide the milled nut over the body of the switch.
NOTE:
For wiring CAN, AUDIO IN or AUDIO OUT a twisted wire pair must be used in each case.