Dyaco CT 900 LED, Руководство по обслуживанию

Страница: 105 / 125

105
10. General Maintenance
WARNING: The effect that the safety level of the equipment can be maintained only if it is examined regularly for damage and wear. The
components which are most susceptible to wear: Belt
、
Idler
、
roller
、
Desk
、
Tread-belt.
Belt and Deck
- Your treadmill uses a very high-efficient low-friction deck. Performance is maximized when the deck is kept as clean as
possible. Use a soft, damp cloth or paper towel to wipe the edge of the belt and the area between the belt edge and frame. Also reach as far as
practical directly under the belt edge. This should be done once every other month to extend belt and deck life. Use water only - no cleaners or
abrasives. A mild soap and water solution along with a nylon scrub brush will clean the top of the textured belt. Allow the belt to dry before
using.
Belt Dust - This occurs during normal break-in or until the belt stabilizes. Wiping excess off with a damp cloth will minimize buildup.
General Cleaning - Dirt, dust, and pet hair can block air inlets and accumulate on the running belt. On a monthly basis: vacuum underneath your
treadmill to prevent buildup. Every 6 months, you should remove the black motor hood and carefully vacuum out dirt that may accumulate.
UNPLUG THE MAINS SUPPLY BEFORE THIS TASK.
Belt Adjustments
Tread-belt tension adjustment - Belt tension is not critical for most users. It is very important though for joggers and runners in order to provide a
smooth, steady running surface. Adjust- ment must be made from the rear roller with the 6mm Allen wrench provided in the parts package. The
adjustment bolts are located at the end of the step rails as shown in the diagram.
Tighten the rear roller only enough to prevent slippage at the front roller. Turn the tread-belt
tension adjusting bolts 1/4 turn each and inspect for proper tension by walking on the belt and
making sure it is not slipping or hesitating with each step. When an adjustment is made to the
belt tension, you must be sure to turn the bolts on both sides evenly or the belt could start
tracking to one side instead of running in the middle of the deck.
DO NOT OVERTIGHTEN – Over tightening will cause belt damage and premature bearing failure. If you tighten the belt a lot and it still slips, the
problem could actually be the drive belt - located under the motor cover - that connects the motor to the front roller. If that belt is loose it feels
similar to the walking belt being loose. Tightening the motor belt should be done by a trained service person.