- 18 -
Insert the Aluminum Spacers into the three End Insulators. as shown in
Figure 14
.
Figure 14
At the ends of the three brackets there are two holes. These holes line up with the two holes in the
End Insulators.
Install one End Insulator
(with Aluminum Spacer) on
each of the Top Hat
Brackets. You will also be
installing one wire (with
ring terminal). Use the
hardware as shown in
Figure 15
.
Note the positioning of the
End Insulator - all three are
installed so they are on the
same side of their respective
brackets. You can refer to
Figure 17
, which shows the
completed assembly.
Route the wire through the
last opening in the End
Insulator as shown in
Figure 15
. Note how the
wire exits the End Insulator.
Figure 15
