Dvorak Spider ILD01, Руководство по обслуживанию, Страница: 32 / 98

32 / 98 SM-1 Ev4/100901
6.15 Exchange of the angle gear UNI M8
Dismount:
-
First, mark the original position of the wheel suspenders, console, and distance rings
- Lift the mower (the wheels must be at least 150 mm over the ground)
- Turn the suspenders in the straight direction
- Dismount the console (see 6.16 Exchange of the driving belts SPA 1650 LW )
- Pull the pulley out
- Support the wheels to secure them against slipping out
- Dismount the wheel housing (see 6.20 Exchange of the wheel housing )
- Dismount the cover of angle gear on the bottom part of the arm (ATTENTION – this sheet secures the
wheel suspension from slipping out) (Picture 76)
- Pull out the angle gear
Mounting:
Don´t forget to put on the Stop ring on the new angle gear (Picture 75)
- Screws of the angle gear cover have to be glued (LOCTITE 243)
-
The wheels place in the teeth in straight direction (or adjust the steering geometry after mounting)
- MIND a position of the needle bearing securing ring in the arm groove
- Lubricate the needle bearings, pulley shaft and the steering teeth transmission (grease) (Picture 75)
- ATTENTION!!! Mount by hands only – clean the shaft, lubricate it and push in smoothly by hands!!!
- Tight 4 screws, use thread glue LOCTITE 243
- Put on spacing ring 17-22 v41, key, belt pulley, spacing ring 17-22-v5,5
- Mount the belt on the hydraulic motor pulley and console pulley
- Push the console on the shaft by hands
- Tight the screws, follow the order 3, 2 a 1 (Picture 74)
- Secure the screw 2 with glue (LOCTITE 243)
- Check the clearance between transmission and the arm, approximately 4mm (Picture 73)
- Mount the wheel housing (see 6.20 Exchange of the wheel housing )
- Tight the by-pass valve of the pump
ATTENTION: see section Service Bulletin 8.3 Wheel suspension – lubrication
Picture 73 Picture 74
Picture 75 Picture 76
4 screws
Stop
ring
Clearance
approximately 4 mm
filling grease MOBILUX
EP004 100cm3 (100ml) for each