Dutchess JN, Общие правила безопасности, руководство по установке, инструкции и каталог запасных частей, Страница: 15 / 39

4. The exterior should be wiped down with a soap and
water solution. (Do not use solvents).
5. The paint is abrasion, impact, moisture resistant, and
USDA approved. If the paint should become damaged,
a similar type paint should be applied.
6. The motor belts will require tightening, and when worn,
replacement. For tightening, see adjustments Item 2,
page 5.
BELT REPLACEMENT
Figure 24
To replace the belts, see Fig. 24. Remove covers, loosen
belt adjusting lock nut and knob totally. Remove belts
from motor sheaves at top. Belts will slip down off driven
sheaves over bearing cup. Pull pin from lift arm and
remove belt.
To install belts, reverse procedure and complete
tightening belts as shown in Adjustments, item 2 page 5.
7. To service crank bearings, slide pins, and follower (Fig.
25), remove crank plate, page 15, Item 37, by
removing the forward center plastic plug, Item 2, and
hex shoulder bolt, Item 1 from the crank plate. To do
this, the silicone in the center of the plug must be pried
out, then insert the bolt provided
(1/4”-20 x3/4” Hex Hd
Capscrew) with your warranty packet into the plug, and
turn clockwise until the plug can be removed. After
removing the hex shoulder bolt, graspboth sides of the
crank plate and lift.(See maintenance schedule, page
11) Replace crank plate. Remove bolt from plug and
tap plug back into crank plate until flush with surface.
Apply a small amount of silicone into hole in plug.
Save the bolt or future use.
Figure 25
The components of this machine require very little
maintenance, but all mechanical equipment does require
periodical service for proper operation and extended life.
A regular lubrication schedule should be established and
followed. The frequency of lubrication must be determined
by the user.
LUBRICATION
Type of Lubrication:
OIL: Must be a USDA approved food grade.
May be a spray type.
Grease: Must be a USDA approved grease.
CAUTION!
The power switch is to be in the OFF position
and the machine disconnected from the
power source before servicing.
IMPORTANT
Always clean excess grease and oil from
the machine and surrounding area.
10