Dutchess JN, Общие правила безопасности, руководство по установке, инструкции и каталог запасных частей, Страница: 14 / 39

The entire head assembly (head, divider, ring, & pallets)
can be placed in a dishwasher for daily cleaning. These
components must be allowed to cool to room
temperature before operating.
Special care should be
taken when placing into dishwasher to be sure
sprayer heads can not hit head assembly or damage
could occur to head and/or dishwasher.
CAUTION!
Do not drop or bump the dividers or damage will
occur and the machine will not operate properly.
UPPER MACHINE CLEANING
The upper section must be cleaned, using a soap and
water solution. Perform this operation with the head
assembly off the machine.
1. Remove the front and rear canopies by lifting up and
out.
CAUTION!
Place a solid block between the crank plate and the
trip plate, to prevent movement, before proceeding.
2. Remove trip spring assembly by loosening and
removing the shoulder bolt (Fig 22).
Figure 22
3. Remove the trip lever by loosening and removing the
shoulder bolt (Fig. 23).
4. Wash the entire upper area with soap and water.
Rinse, then wipe dry all shafting and components.
5. Shafts, spindles, pins and pivot points should have
lubrication applied. Lubrication should be a USDA
approved oil ONLY! This oil should be applied
sparingly. Apply oil to a clean, soft cloth and wipe these
moving parts, see Lubrication on pages 10 - 11.
Figure 23
Reassemble the components:
1. Place the trip lever in slot on shaft, then install
shoulder bolt and tighten (Fig. 23).
2. For trip spring replacement, place rod end on trip lever pin,
install shoulder bolt and tighten (Fig. 22).
3. Install head assembly per instructions on pg. 7.
WARNING!
Machine must be fully assembled before operating.
Wipe total exterior of machine with hot soapy water. Rinse
with clear water, and wipe dry.
MAINTENANCE
WARNING!
The power switch is to be in the OFF position, and the
machine disconnected from the power source, before
servicing or cleaning. Always check before beginning
these operations.
This machine requires minimal maintenance, but a regular
maintenance schedule should be established to assure
many years of trouble-free service.
1. The head assembly should be cleaned daily. See “head
assembly removal and installation”, pages 5-7 for removal
of head. The head assembly can be placed in a sink or
dishwasher for cleaning.
2. The pallets are made of Lexan, and can be washed daily.
The pallets will scratch during regular use; however, do
not use metal or other sharp objects on the pallets.
3. The crank plate should be wiped clean before each
installation of the pallet. If soiled, a soap and water
solution should be used. Scrape with w plastic scraper
if soil buildup has occurred.
9