Dutchess JN, Общие правила безопасности, руководство по установке, инструкции и каталог запасных частей, Страница: 12 / 39

11. Remove head assembly (Fig 12, No. 1). This head
can now be cleaned. (See pages 8 - 9).
Figure 12
HEAD REPLACEMENT
1. With pallet in place, position head assembly (Fig. 13,
No. 1) in center of pallet with handle in front.
Figure 13
2. Release the trip lever, and slowly lower the handle.
Watch the lower end of the ram (Fig. 11) insertion into
the head. Align the head as necessary to complete
insertion.
WARNING!
Keep hand from between the head (Fig. 14, No. 2)
and the trip plate (No. 3).
Figure 14
WARNING!
Do not release handle from your hand, until the
handle is raised to its uppermost position.
3. Rotate the head assembly, Fig. 15, No. 1, ¼ turn
clockwise. Alignment pin at front of trip plate, Fig. 15,
No. 2, will engage in hole in head assembly, No. 1.
Figure 15
4. Raise handle to its uppermost position.
5. Tighten both hand knobs (Fig 15, No. 3).
6. Set ring (Fig 16, No. 1) on center of pallet.
7. Lower handle slowly and align ring (No. 1) with head
(No. 2) continue down with handle, align ring slots with
arms (Fig. 16, No. 3).
Figure 16
8. Hold handle in this position, rotate ring clock-wise ¼
turn, grasp ring at outer edge, keeping fingers out of
divider/plug area.
9. Raise the handle to its highest upright position.
10. Replace front and rear canopies by aligning key holes
with pins and sliding downward.
CAUTION!
The ring must be rotated clockwise until the
pin rests against the ring arm.
7