Duro TITAN DSBF300, Руководство по эксплуатации и установке

Страница: 8 / 12

8
CLEANING THE PUMP
The following steps are for service and cleaning of the pump;
1.
Always disconnect the unit from the power supply before any servicing.
2.
Disconnect discharge piping and remove pump from sump/sewage basin.
3.
Submerse pump in a disinfectant solution (Clorox or Chlorine) for at least one hour before disassembling pump.
4.
Detach volute from pump by removing the seven (7) screws. Do NOT remove countersunk screws holding seal plate
to stator housing or warranty will be void.
5.
Gently pry volute from seal plate using a screwdriver.
6.
Use a flathead screwdriver to hold the shaft.
7.
Turn the impeller counter clockwise to release.
8.
Remove debris from around the shaft and impeller, then clean impeller and inner volute using water. Do NOT use strong
solvents (paint thinner, gasoline) which may damage the plastic.
9.
Reattach volute and reassemble.
Alterations to the power cord voids the warranty.
Do NOT use this pump, to pump liquids (water), in excess of 37.8 °C [100 °F].
Disassembly for Cleaning:
Item # Description
1
302701 Pump Volute (8097)
302728 Pump Volute (8098)
2 302702 Rubber Gasket
3
302703 Impeller (8097-78.4 MM)
302704 Impeller (8098-76.2 MM)
4 Pump Bracket
5 302705 Screw
6 302706 Mechanical Seal
7 Stator
8 302707 Lip Seal
9 Bearing
10 Rotor & Shaft
11 Pump Gasket
12 Bearing Housing
13 302708 Lock Nut
14 302709 Washer
15 302710 Rubber Seal
16 Top Cover
17 Screw
18 Grommet
19 Cord Screw
20 Power Cord
21 Capacitor
22 Handle
23 Oil Plug