DURKOPP ADLER H-Type 969, Инструкция по эксплуатации

Страница: 30 / 90

Setting the drive
28 Service Instructions 969 - 01.0 - 12/2015
6.2 Adjusting the positioning of the machine
The machine will stop automatically at two angular positions on the main
shaft (of the handwheel). To ensure that the machine stops properly at
these positions, you need to set the reference position for the handwheel.
In order to ensure that the reference position is set properly, the drive ratio
between motor and main shaft must be entered correctly into the control
program of the machine.
Fig. 19: Adjusting the positioning of the machine
6.2.1 Determining the drive ratio in the control program
Setting steps
1. Select parameter setting mode on the OP1000 control panel (1) and set
the parameter t 08 19 (

DAC b asic/classic Service Instructions ).
2. Manually rotate the handwheel (2) by at least 2 turns.

The display on the control panel will show a new value for the drive
ratio.
3. Press the OK key to confirm this new parameter value.
6.2.2 Adjusting the reference position of the handwheel
Proper setting
The reference position is at 105° on the handwheel scale (2).
Setting steps
1. Select parameter setting mode on the OP1000 control panel (1) and set
the parameter t 08 10 (

DAC basic/classic Service Instructions) .
2. Manually rotate the handwheel (2) by at least one turn before turning it
to 105° on the scale (

p. 20).
(1) - OP1000 control panel (2) - Handwheel
①
②