Duratuf MARLBOROUGH, Руководство по сборке

Страница: 14 / 30

14 14
14
WALL CLADDING - BACK & ENDS
• Note - When attaching wall cladding always ensure
top sheet is level with top plate and ends of sheet
are fl ush and parallel with studs. This will ensure that
wall panels are square. (Always screw wall sheets
through the trough of the profi le)
• Position 1st sheet fl ush with top of top plate and both
ends of sheet are fl ush with outside of studs.
• Using a 25mm tek screw, screw one end of sheet to
frame. (Note - screw approx 30mm back from end
of sheet. Corner fl ashing will cover screws when
attached.)
• Repeat at the other end, ensuring top of sheet is fl ush
with top of top plate.
• Screw sheet near the bottom, ensuring the ends of
sheet are fl ush or parallel with stud.
• Position 2nd sheet underneath the fi rst sheet,
repeat above. Make sure the above sheet is always
overlapped correctly.
• Using four 25mm tek screws, repeat above steps
ensuring sheet is level and fl ush at each end.
• Position and screw bottom sheet using four 25mm tek
screws.
• Using 25mm tek screws in the middle of the sheet,
screw the three wall sheets off as per plan. (fi ve
screws per end of each sheet and two in the middle).
• Repeat above steps with each side wall.
WALL CLADDING - FRONT
• Position and screw sheet above doorway ensuring
sheet is fl ush with top of top plate and both ends
of sheet are fl ush with outside of studs. (Use three
screws in each end and three screws along top plate
and one in each 320mm stud)
• Fit remaining sheets each side of doorway and screw
off as above.