Duratrax Delphi Indy Car, Руководство по сборке и эксплуатации

Страница: 8 / 16

❏
5. Remove the twist-tie from the receiver antenna. Route
the receiver antenna up to the antenna mount on top of the
upper plate. Locate the antenna tube and retainer. Thread the
receiver antenna through the retainer and then through the
antenna tube. Press the retainer partially onto the antenna
mount then insert the antenna tube into the retainer. NOTE:
The antenna will be longer than the antenna tube. DO NOT
CUT OR COIL THE ANTENNA WIRE. Tip: Run the antenna
wire through your fingers to straighten out the kinks before
running through the antenna tube.
❏
6. Plug the ESC and steering servo leads into the
appropriate slots in the receiver. Note: Refer to the
transmitter's instruction manual to determine the proper
slot for each.
❏
7. Remove the steering servo saver from the steering
servo. Connect the battery to the ESC. Center the trims on
the transmitter then turn it “on.” Then turn the ESC “on.” Place
the servo saver back onto the servo so that the wheels are
both facing as straight forward as possible. Secure the servo
saver onto the servo using the servo horn screw included
with the servo. Note: The steering may need to be fine
tuned using the trim adjustment on the transmitter.
❏
8.Decal the body as desired.
NOTE: The Sprint electronic speed control is pre-set at
the factory.The following instructions should be followed
if the pre-set needs to be changed. During normal
running, the speed control should be switched “on” and
not given input from the transmitter for 3 seconds. This
bypasses the set-up stage of the ESC.
❏
1. Turn the transmitter on.
❏
2. Note: The set-up portion of the Sprint ESC occurs
in the first 2 seconds when the speed control is turned
on. Set the throttle trim of the transmitter at neutral.
❏
3. Turn the electronic speed control on. The green LED
will light up for approximately 1 second.
❏
4. Squeeze the throttle trigger, the red LED on the ESC
will light up to indicate full forward is now being operated.
❏
5. Push the throttle trigger to full reverse, the green and
red LED's on the ESC will light up to indicate that full
reverse is being operated.
❏
6. Finally, let go of the trigger. The speed control will hold
this setting until it is reset.
ELECTRONIC SPEED CONTROL SET-UP
8