18
5.16 STORE SETUPS 66
V
66 #
Megavoice stores set ups into non-volatile memory from RAM. Set up must be stored
with this when everything is set up. On power up set up is read from this memory.
Megavoice replays Ok tone and displays STORED SETUP. Recordings and day/night
mode changes do not need to be stored with this.
5.17 SETUP DEFAULTS 67
V
67 #
Megavoice uses the factory default values for set ups. This do not interfere with the
recorded messages. Megavoice replays with OK tone and displays STORED INITS. It is
then possible to store there defaults (see 5.16) Also it is possible to take defaults if
Megavoice is powered up with switch 5 down. This is used if answer delay is too long.
5.18 CHANGE PASSWORD 7
V
7 pppppp #, wait for OK , retype
V
7 pppppp # wait for OK.
pppppp= password with 6 digits.
Default value is not here but written in 3.4.
This command must be entered twice. If password is 000000, password is no longer
used. Programming state can be reached even with
V
0# command without password.
Password can be by-passed with front panel switch 8 if necessary.
5.19 RESET DISPLAY 95
V
95 #
Resets the display unit. This command is sometimes used if the display is connected with
Megavoice on. Display should be connected always with megavoice off or dtmf
transceivers might have problems.
.
5.20 DISPLAY MEMORY 99
V
99 #
Megavoice displays the software number >SOFTWARE V3.0<, total memory in s like
MEMORY=128S, free memory MEM FREE=112S and how many lines and messages are
available CH=02 MSG=09.
5.21 RESET 0**
V
0
V V
#
Megavoice resets it self totally into power on state. Lines are relased. The system can be
checked with this command.
18
MEGAVOICE 2000 V.3.1 MANUAL V.2000-09-20
