Duralloy MULTIMIG 200 PFC MV, Руководство пользователя

Страница: 10 / 28

Keep your welding machine in top condition
The DURALLOY MULTIMIG 200 PFC MV does not require any
special maintenance, however the user should take care of the
machine as follows:
• Regularly clean the ventilation slots.
• Keep the casing clean.
• Check all cables before use.
• Check electrode holders, work lead/clamps and welding
torches before use.
• Replace worn electrode holders and earth clamps, which do
not provide a good connection.
• Replace worn consumable parts in a timely manner.
• Use a soft cloth or brush to clean electrical components.
• Do not use liquid cleaning products, water or especially
solvents.
• Do not use compressed air to clean electrical components as
this can force dirt and dust further into components, causing
electrical short circuits.
www.duralloy.net.au | 1300 369 456
CARE & MAINTENANCE
10
MULTIMIG 200 PFC MV
OWNER’S MANUAL
• Check for damaged parts. Do not use the welderwith
damaged parts.
• A damaged welder must be carefully checked by a qualified
person to determine that it will operate properly. Check for
breakage of parts, mountings and other conditions that may
affect its operation. An authorised service centre should
properly repair a damaged part. Have your welder repaired
by an expert.
This appliance is manufactured in accordance with relevant safety
standards. Only experts must carry out repairing of electrical
appliances, otherwise considerable danger for the user may
result. Use only genuine replacement parts. Do not use modified
or non-genuine parts.
Storing the Welder
When not in use the welder should be stored in the dry and frost-
free environment.
WARNING!
Before performing cleaning/maintenance, replacing
cables / connections , make sure the welding machine is
switched off and disconnected from the power supply.
WELDING SETTINGS
Use a chart as guide only, as optimal settings will vary with weld joint type and operator technique. Cells left blank not recommended combination for
effective welding results.
*Inductance adjustment controls the rate of the welding current rise and fall as the welding wire contacts the workpiece (known as short circuit). More
inductance increases the short circuit time and decreases the short circuit frequency rate. This causes a wider and more penetrating arc, useful for
thicker weld joints. Less inductance will create a narrow, more focused arc. This effect can also be used to fine tune the arc to produce less splatter.
Wire speed, wire size and type, shielding gas will all change the effect that the inductance has on the welding arc. Inductance setting will have no
effect on MIG spray transfer process (as opposed to short circuit process), MMA or TIG welding process.