Durafly Curtiss P-40N, Инструкция по эксплуатации

Страница: 6 / 40

ASSEMBLY
1. Out of the box your P-40N comes with reinforced foam hinges. However before assembly can begin,
each hinge line must be flexed back and forth 5-6 times to reduce tension, and load on the servo.
Do this for all control surfaces before continuing.
NOTE: Your P-40N comes with a selection of scale decals/markings to choose from.
Application of these decals is highly recommended BEFORE you begin assembly of the
model. Please refer to ‘Decal application’ on pages 17-18 of this manual for illustrated
guides on how to apply each set.
2A. Locate both aileron and flap control horns, plates and push rods. Screw each horn in place as
shown below using the screws provided. Aileron horn screws pass through the aileron and screw
into the receiving horn plate. The flaps screws screw directly into the plastic of the flap.
2B. Raise each servos horn until at 90 degree’s to the wing and attach the push rods to the outer holes
of both servo and control horn. Adjust the plastic clevis on the rods until the ailerons are neutral
and the flaps are closed. Further adjustments can be made later during the ‘set-up’ stage of the
manual.
2x6mm
1.7x10mm
3