Durafly Curtiss P-40N, Инструкция по эксплуатации

Страница: 38 / 40

1. The battery is not fully charged.
2. Elevator servo is reversed.
3. CG too far backwards.
1. Charge the battery.
2. Change servo direction via Tx.
3. Move battery forwards.
1. Transmitter/Receiver batteries
are flat.
Problem Cause Solution
Motor does
not turn
1. Battery is not fully charged.
2. Transmitter battery low.
3. Motors not connected.
4. The motor is damaged.
5. Receiver is not bound to Tx.
6. ESC in set-up mode.
Control surfaces
not moving with
stick input
Model does not
fly straight
Model does not
climb well
Limited Radio
Range
1. charge/replace batteries.
Model moves
backwards
1. Prop installed backwards 1. Turn the props around.
1. Charge the batteries.
2. Install a full charged battery.
3. Check for connection
between the ESC and motor.
4. Replace motor.
5. Consult Radio manual and
go through bind procedure
again.
6. Hold model and move
throttle to full position then
back down to idle.
1. The servo lead is connected
to Rx incorrectly.
2. The servo is damaged.
1. Make sure the servo leads
are connect properly.
2. Replace servo.
1. Control surfaces not centered.
2. CoG is not in the correct position.
1. Adjust the trims on the
transmitter.
2. Re-position lipo as
suggested.
35
TROUBLE SHOOTING: