42
9-2. OPERATING PRECAUTIONS
1
If double-feed occurs frequently and
cannot be corrected, reduce the
amount of paper on the paper feed
table until the middle of the guide
(approx. 25mm)
As the specific gravity of this type of paper is
higher than that of normal paper, they tend to
stick together, causing double-feeding to
occur frequently.
The amount of paper loaded on the table is
therefore reduced.
2
Adjust the paper feed pressure
adjusting lever to “3”.
• If the paper slips, gradually raise the paper feed
pressure one level at a time , from “3” to “4”, until
the appropriate paper feed pressure is obtained.
• When the paper slips, the display shows “-
¡-”
and the unit will stop. Raise the paper feed pressure
one level when the unit stops.
Set the paper feed pressure within the range
of 3 to 5.
3
Next, open the top cover and adjust
the separator pressure.
• Set the separator pressure adjusting dial to “2.5”.
• If the paper sticks and several sheets of paper are
fed at one time (double feeding), gradually raise
the separator pressure adjusting dial 0.5 at a time
until the appropriate separator pressure is obtained.
Set the separator pressure within the range of
2.5 to 3.5.
• The separator pressure may have to be set to 3.5 or
above if the paper feed ring or paper separator, etc.
is worn out.
But try to set the pressure at the lowest level
possible.
9. USING ART/COATED PAPER
Paper
25mm
Guide
Paper feed pressure adjusting lever
Separator pressure adjusting dial
