Duplo DC-645, Инструкция по эксплуатации, Страница: 38 / 106

37
12
Prog
ram JOB f
o
r DC-645
Via Computer
(J
O
B
C
re
a
to
r)
Gutter Cuts .................................... 10 mm / 10 mm (Distance between finished documents
(top / bottom))
When aligning 2 or more cards in lengthwise direction, it is possible to have a gutter cut between
each cards. The distance should be 4 mm or more.
IN following job, gutter cuts are 10 mm in length.
Crease ............................................. 65 mm
Specify the position of the crease on the cards.
Barcode Reading ............................ ON
Auto Cut ......................................... ON
AIR KNIFE .................................... Compressed air is blown out to loosen the document.
This is to prevent double-feed.
FAN REGISTER ........................... Document skewing in feeding area is corrected. When
processing light weight document, turn this function
OFF as it may cause a paper jam in feed area.
SLIT GUIDE .................................. When any slitters are not used, these slitters act as
paper guide to stabilize the paper conveyance.
Recommended for light weight document.
AUTO CUT .................................... Lead margin, trail margin, and any gutter cuts (shorter
than 85 mm) are finely cut and dropped into the waste
box. When documents do not have lead margins or trail
margin, this must be turned off.
CREASE DEPTH .......................... This sets the depth of the crease when creasing a
document. Set to MAX for heavy paper and MIN for
light paper.
SPEED ............................................ This is used to select HIGH / LOW processing speed.
Set to LOW for better processing precision.
Continue Page
• • •
JOB Creator Settings