Duke DQ GEN-102, Руководство оператора с иллюстрированным перечнем запчастей

Страница: 43 / 105

185232 33
Soft Serve Freezer Model GEN-102
Important:
Do not twist the hose assembly while
installing.
18. Check to ensure the transfer hose
is straight and centered on the roller
assembly by observing the locating
line. The line should be in the same
position at the inlet and outlet guides
of the roller bearing support, as shown
in figure 9-6.
19. Swing the shoe over hose and tighten
the swing clamp hand knob in place.
20. Insert the air tube into the retainer in
the back of the cabinet.
21. Insert the MTS cover over stud. Hose
clamps should be exposed. Tighten
cover knob. Hand tighten only.
22. Loop the braided hose towards you
and slide the hose over the cylinder
inlet tube. Tighten the clamp. Make
sure the braided hose is not twisting
transfer hose.
Important:
The MTS will not operate unless the
cover is installed and secured by the
hand knob.
23. Install pressure relief hose on drain
port and into the hole on top of the
mix tank cover.(figure 9-6)
Figure 9-6 MTS
9 Assembly
(continued)
PORT AIR/MIX ASSEMBLY
CORDSET-MIX LEVEL
AIR METER
AIR METER TUBE
SWING CLOSED
ROLLER SHOE
ROLLER SHOE
MIX TRANSFER HOSE
NO TWIST. NOTE RED LINE
BRAIDED HOSE ASSY
RETAINER-AIR LINE
CYLINDER INLET
CONNECT THIS CLAMP LAST
HOSE CLAMPS
PUMP COVER
SWING IN SHOE
CLAMP