Duevi CE 60-3 GSM, Руководство по установке

Страница: 9 / 39

9 CE60-3GSM - Installer
WARNING: IMPORTANT INFORMATION REGARDING THE SIM CARD
1. DO NOT INTRODUCE OR REMOVE THE SIM CARD WHEN THE CONTROL PANEL IS ON (either by
the power network or the battery).
2. Control panel is able to work with any SIM card, pre-paid or with contract of TIM, VODAFONE
and WIND operators.
3. Before using any SIM card, be sure that the PIN code is disabled. To be sure, introduce the SIM
card in a mobile phone, verify that there is no PIN code request when turned ON, and if there
is, disable the use of the PIN code with the phone configuration.
4. DISABLE any active service of the SIM, like call forwarding, answering machine, etc. To verify
the status of these configurations, introduce the SIM card in a mobile phone and call the service
number:
##002#
. This string is valid for all operators. This call will be confirmed with a
message of “Calls forwarding disabled” (each mobile device has its own viewing modality).
5. Clear all data from the SIM card (ex.: Received messages, contacts,…)
•
ALWAYS execute all wired connections to the control panel with the power supply OFF (no 230 V , or
battery). After all wiring connections are done, short circuit all not used wired inputs IN1 , IN2 and IN3 to
connector +VS .
•
Exclude internal tamper protection by closing the jumper JP2 (remember to enable again once the settings
have been done).
•
If external tamper is used, it is mandatory to open jumper JP1 .
•
Position micro switch
INT1
to OFF.
If control panel is not turned OFF, verify that jumper JP1 is open.
•
Switch on power line 230 V .
•
Connect backup battery to red and black wirings which are on the connector BAT , respecting the color
matching (red wire = positive pole “ + ”; black wire = negative pole “ ― “):
Battery must be a lead rechargeable type 12 V .
Battery will allow the system to work even during shortage of main electrical power supply.
At this point the control panel can be put in operation by moving switch
INT1 to the ON position.
Start up time > Wait for about 5 seconds before the control panel start running.
INT1 could be considered an emergency switch, when it is on the OFF position the control panel is disabled but
voltage on the outputs are kept ON for all the peripherals.