Duevi CE 60-3 GSM, Руководство по установке

Страница: 20 / 39

CE60-3GSM – Installer
20
7.1. Learning by “tamper”
This mode allow to learn the radio devices just operating the tamper switch onboard (so not any radio code of
the device).
The control panel uses this mode by default when entering in “Radio Zone Learning”.
7.2. Learning by “any radio code”
This mode allow to learn the radio devices by any radio code they transmit.
It is possible learn the sensors just make a detection:
Learning 0
Radio Zone 01 P
Learning _
Radio Code 02 P
At each quick press of the “ O ” key you go to the next memory location
(from “Radio Zone 01” to “Radio Zone 60”)
Learning X
Radio Code 02 P
If the control panel receives a signal from the sensor correctly, it will
confirm its memorization with an “
X ” in the place of “ _ ”.
If the memory is not possible the control panel will emit three “beeps”.
Learning 0
Radio Zone 02 P
Once positioned in the desired zone:
Press “X” key quickly > You will see “ _ ”: the control panel is now ready for
another sensor code to be programmed.
Hold down “ X ” key > Delete the current sensor.
O
X
60 is the maximum number of wireless sensors that can be memorized.
Learning *0
Radio Zone 01 P
At each quick press of the “ O ” key you go to the next memory location
(from “Radio Zone 01” to “Radio Zone 60”)
O
60 is the maximum number of wireless sensors that can be memorized.
“ X ” = memory position already occupied by other device
“
0
” = memory position free
“ P ” = the device is perimeter type
“ T ” = the device is volumetric type (PIR)
Act on tamper switch of the device: