Duerkopp Adler 4181i, Инструкция по эксплуатации

Страница: 33 / 38

8
- Loosen the screws (9) by clutch lever motor and turn the
motor with lever in such a way that the lever (10) would be in
direction of the rod axis (1).
- Adjust angular turning of treadle (11). The position of trea-
dle is correctly adjusted if there is a square angle at the shin-
bone of the operator to the treadle.
- Fasten knee lever (12) onto the shaft (13) and adjust it in a
position that it is shown in the picture (slightly leant out).
4.7 Electrical connection of machine head to the stopmotor
4.7.1 Connecting cable
Together with the machine head there is supplied a connecting cable for the following drives:
EFKA DC 1600/DA82GA 3311 and higher
EFKA VD 552/6F82FA 2315 and higher
EFKA VD 554/6F82FA
When there is no drive specified, a cable without any connecting power plug is supplied (mind the caution 2.3).
For the information sake, there are given the respective circuit layout.
The colours are indicated with numbers in brackets (6 – green, 7 – blue, 8 – pink, 9 – black, 10 – white, 11 – violet, 12 – yellow,
13 – red, 14 – grey, 15 – brown). Included insulating covers PVC (5) are put on the bunches and they are put together with
remaining part of cable insulation by means of contracted tube (4) (it is heated up with fire of lighter).
Power connecting cable is marked off with dotted line in circuit layout.
Stopmotor S359 600045 XXX - EFKA DC 1600/DA82GA
Stopmotor S359 600052 XX - EFKA VD 552/6F82FA
Stopmotor S359 600056 XX - EFKA VD 554/6F82FA
3 1 2
12
13
18 mm
11
2
1
9
9
10
9
www.promelectroavtomat.ru