Duerkopp Adler 4181i, Инструкция по эксплуатации

Страница: 35 / 38

10
3 2
1
Wiring diagram of work trimmer and its supply
4.7.3 Fastening upper cover belt, position reader,
control panel of stopmotor and thread stand
- Screw the stop to the belt guard.
- Assemble upper cover belt and hand wheel according to
par.4.5.
- Set the position sensor (3) on the handwheel pin so as to
match the stop groove of the position sensor with the stop
(thus immobilizing the position sensor).
- Fix the position sensor by retightening the two hexagonal
screws.
- Fix the control panel of stopmotor:
- Stick the panel V 810 (1) by stopmotor EFKA on the machine
head (if any). Defat the contact surface properly. Stick the
clip (2) on the cover belt.
- With the Efka stopmotor, mount the holder (4) on the panel
V820 (5) (if any) using screw and screw on the holder with
the panel to the stand table.
- Assemble the thread stand so that its arms would be parallel
to the longer edge of a table top.
4.8 Wiring of the work trimmer
- Remove the cover of the work trimmer power supply (1).
- Check the connection of the power supply cable with the
primary winding of the transformer and adapt it, if needed,
as specified in par. 4.2. Mount the cover.
- Tilt the machine head, pass the socket of the connector
through the hole in the front section of the oil tank, and fix it
to the stationary plug of the connector (3) under the bed
plate of the machine head.
1
2
60mm
3
80
4
5
110
www.promelectroavtomat.ru