9
Programming with Smart Commmand
To programme your Vitro-i with a
Gateway you must pair the
heater to the Gateway. First you must activate the
pairing/discovery mode in the Gateway. Details
of this can be found in the
instruction manual.
Once this is done press the CONFIG button
on the heater and use the + or - key until the RF
icon flashes. Press OK and ‘Link’ together with
an antenna icon will appear in the top right of the
screen.
Another way to pair the heater is to press the
OK
button for 3 seconds while the heater is in one
of the main modes (OFF, AUTO, MANUAL).
Your Vitro-i heater is now ready to accept
programme instructions from the Gateway (you
will need to complete
web
activation).
If the heater has been linked to the Gateway and
for some reason communication is lost, the Link
icon disappears and the antenna
starts flashing.
Keypad Locking (Anti-Tamper)
The keypad can be locked to prevent any
unauthorised person (children, people in public
places, nurseries, offices, hotels etc.) altering the
settings of the heater. To lock the keypad depress
and hold the + and – buttons at the same time for
3 seconds until “Lock” appears on the screen. Any
button presses will be ignored and “Lock” will be
displayed on the screen.
To unlock keyboard, once again press and
hold + and - for 3 seconds until the word “Lock”
disappears.
When the keypad is locked the heater
will still receive communications from the
Gateway.
Advanced Settings
To enter the advanced settings mode, press
CONFIG
while the heater is in one of the main
MODES (OFF, AUTO, MANUAL). The following
window will appears:
Now press the
CONFIG
button for 5 seconds
and C1 appears on the screen.
To select one of the five advanced settings (C1
to C5) use the +/- keys and choose the required
mode by pressing OK. The advanced settings are:
1.
C1-> ºF or ºC
2.
C2-> Type of control
3.
C3->
T
emperature Compensation
4.
C4-> Firmware version
5.
C5-> Open Window detection
Degrees Fahrenheit or Celsius (C1)
Select ºC or ºF with the +/- keys and confirm
with OK button .
Type of Control (C2)
You access the setting mode control, showing the
type of control currently used. There are 4 types
of control PID, hysteresis of 0.25ºC, hysteresis
of 0.35ºC, hysteresis of 0.50ºC and hysteresis of
0.75ºC.
To change type of control press +/-. Confirm with
OK.
The screens shown are:
T
emperature Compensation
(C3)
In this mode the display will alternate between
the temperature compensation (offset) and the
measured temperature with offset applied. Alter
the offset with the +/- buttons and confirm with OK.
Temperature compensation can be adjusted up
to +/- 3ºC
