8
9
When the temperature setup icon
starts
flashing, press OK to scroll through each mode.
Press the +/- button to change the temperature
of each mode then press
OK
to confirm and go to
the next MODE and exit to the temperature setting
screen by pressing CONFIG.
To start programming press and hold
CONFIG/
PROG
button for 3 seconds and the following
screen will appear:
Programming starts on Monday at 00:00 and
is set by choosing the required Mode for each
hour of the week. Use the
OK
button to choose
between Comfort
, Economy
or Frost
Protection modes. On the screen programme
hours will show two blocks for Comfort, one block
for Economy and no blocks for frost protection).
After choosing the mode press the +/- buttons to
select the next hour to be programmed. When a
full day has been programmed the screen moves
to the next day.
Once each day of the week has been
programmed the clock must be set.
Press the
CONFIG
button to exit from
programming screen and enter the time setting
screen.
To select the day of the week (1=Mon, 7=Sun)
press +/- buttons and confirm with the
OK
button.
Next select the hour, confirm with
OK
and then
select the minutes and confirm pressing
OK
once
more.
If a heater is paired with a
Gateway, time setting is not required as it
recognises the system’s time automatically.
Manual Programming
Setting Programme and Clock
To assist with programming the LCD screen is
backlit and will stay illuminated for approximately
10 seconds after the last button is pressed.
When the heater is operational and the room
temperature is lower than the set temperature
the heating symbol will be shown indicating
that the heater is producing heat. When the room
temperature equals or is above the set temperature
the heating symbol will not be present indicating
the heater is not producing heat.
The following screens show
OFF
,
AUTO
and
MANUAL
modes. To chose diferent modes press
MODE/OK
button.
When the heater is in
AUTO
mode the
temperature can be changed by pressing the +/-
buttons. This change will remain active until the
next programme change or until midnight when
the temperature will revert to the preset value.
Use the +/- keys to change the temperature
when the heater is in
MANUAL
mode.
Adjust Programmed Temperatures
Adjusting temperature in the following way will
only effect the temperatures used for programmed
modes.
To change these set up temperatures press the
CONFIG
button and the following screen appears:
