6
7
Figura 3a
Figura 3b
Mounting the Heater
In order to mount the appliance on a wall, it is necessary to first secure the support frame supplied with the appliance
to the wall.
Remove the support frame attached to the rear part of the appliance. To do this first press the two upper clips of the
support frame in order to release the frame from the upper rear part of the appliance and then withdraw the lower part
of the support frame. See Figure 2.
Place the support frame in a horizontal position against the wall and mark the location of the screw holes, as detailed
below and shown in the Figures 3a and 3b below.
1.
Stand the support frame on the floor, lean it against the wall and mark through the top holes, as shown in Figure 3a.
Remove the support frame and drill and plug the wall for the fixing screws.
2.
Attach the support frame to the wall by means of screws in the lower slotted holes and mark through the upper
slotted holes for the top fixing screws. See Figure 3b. Drill and plug for these screws. In this manner the Vitro-i
heater will be mounted on the wall with 205mm between the floor and the bottom of the appliance.
3.
When the support frame is fixed to the wall mount the heater by first attaching the lower bracket and then the top
ensuring the clip clicks into the heater. See Fig 2.
figure 3b
figure 3a
CONTROL OPTIONS
The Vitro-i is designed to be used in conjunction with the
system and APP, providing total control
of your heaters from anywhere in the world via the internet. The APP is available for both Android and IOS devices and
offers the ultimate in control and energy monitoring.
It is also possible to programme each heater individually without the APP by using the inbuilt buttons and LCD screen.
This may be convenient for single heaters however we recommend the
to control multiple heaters.
Finally the heaters can be used in manual mode which bypasses any programming and provides simple On/Off operation.
