MAXIMISING SIGNAL STRENGTH
FINDING NEW STATIONS
DAB MODE
New stations may become available over time. You can
manually start an Autotune Scan by pressing the
SCAN button.
This will conduct a search of radio frequency signals and
automatically add any new stations to the memory. You
will see any new stations on the list when you rotate the
TUNE knob to select a station.
•
•
To perform a scan of UK radio frequencies, press the
SCAN button and the display will show ‘Fast
Scanning’. Your radio will perform the same scan of
Band III DAB frequencies that it did when you first
switched it on. It will take about 20 seconds.
•
•
If using the radio outside the UK, you will need
to perform a full scan of all Band III
frequencies. Press and hold the SCAN button
for three seconds, the display will show
‘Full Scanning’. This will take about one
minute.
15
DAB signal strength can vary greatly in different locations.
Use the signal strength indicator, to help position the radio
in the best position location.
•
•
Press and release the TUNE knob until the display
shows the signal strength indicator.
•
•
Move the radio around and carefully angle the
telescopic aerial to maximise reception, using the
signal strength bar display as a guide.
•
•
The clear unfilled rectangle indicates minimum signal
level required for satisfactory reception; the higher the
number of solid rectangles the stronger the signal.
SHIFT
BAND
INFO
TIMER
SCAN
POOR
SIGNAL
GOOD
SIGNAL
VS.
2008.03.18_DLR1GB_IB.qxp 19/03/2008 12:48 Page 15
