Page 11 sur 15
Notice NT 06
D.T.S. - ZI Parc d’Activités de la Gare - BP N° 27 - 77831 OZOIR LA FERRIÉRE CEDEX – France
Rev. 7
33(0)1 64 40 27 26 - Fax (33.0)1 64 40 20 11 -
www.dtselec.fr
du 19/10/2011
XIN 05 switch
Gear tray
Removable guard
CONNECTION TO TERMINAL BLOCK
Connect the mains, the earth and the + and - remote control with the extended terminal block
placed on the electronic gear tray, after reeving the supply cable through the cable gland.
Advice: 5x1,5mm2
The supply cable must keep some flexibility in order not to pull on the plug in terminal block.
ACCESS TO CONTROL GEAR AND LAMPS
-
Press down the removable guard on the
XIN 05 switch
-
Disconnect the terminal block
CLOSING THE BLOCK
-
Remove the grease from the threads of the cover and housing.
Verify that no solid or dust is located in threads.
-
Put a clear grease in the threads of the cover and housing.
- Insert the gear tray inside the
luminaire housing.
-
Stop the gear tray with the pin.
-
Check the pin is put through the gear
tray and the slide of the luminaire
housing
-
Open the removable guard of the XIN
05 switch.
-
Connect fully the terminal block.
-
Screw the cover fully and press the O.
Ring gasket.
-
Stop the cover with the Chc M4
locking screw (allen wrench N°3).
Pull out the gear tray
Remove the stop pin with a
screw-driver
To put through the
slide of the
luminaire housing
and the second
wave of the gear
tray
