DTS DTS-6D, Инструкция по установке и эксплуатации

Страница: 9 / 72

3
III. INSTALLATION PROCEDURE
The DTS-6D system consist of two major components: The DTS Timecode Reader Head and the DTS-6D
processor (player). The following is a generic procedure intended to supplement the processor installation wiring
diagrams for specific manufacturer's sound systems. Look for these diagrams in Section VIII.
3.1 Timecode Reader Head Installation
•
The Timecode Reader Head is designed to be mounted onto most projectors with a single mounting
bracket.
•
Position the appropriate DTS mounting bracket on the same bolt pattern as the reel arm and bolt securely
in place (see “bracket mounting diagrams,” in Section VIII).
•
Install the Timecode Reader Head onto the DTS mounting bracket and bolt into place with supplied
hardware.
•
Reinstall the reel arm on the top bolt pattern of the DTS mounting bracket.
•
Using some film, align the film path from the reel arm through the DTS reader mounted on a bracket and
to the projector.
•
The DTS timecode reader MUST have a straight film path (no angles or twists) and at least a small
amount of tension. The auxiliary flanged roller on the timecode reader head is used to avoid film “walk
out” and helps to stabilize the film. Additional guide rollers may be added to ensure proper film tension -
most critical on platter systems.
•
Connect the 9-pin timecode cable and route to the sound processor rack for interconnect with the DTS-
6D processor.
•
Two projector (change-over) theaters
Be sure to place each reader head at the same place on the projectors. The offset value must be the
same for the movie to play in sync at both projectors.