dtm slimflash, Руководство пользователя

Страница: 20 / 28

20
3. Installation of a photocell and signaling /
lighting lamps
3.1. Installation of a photocell
For the photocell to function properly,
the transmitter and receiver should be installed
40 - 60 cm above the ground. The distance
between the transmitter and the receiver should
not be less than 1 m. The photocell has the angle
of view adjustment both in the receiver and in the
transmitter. Coaxial assembly is not required,
only the maximum angles of rotation of the
electronic boards in the transmitter and receiver
housings should be taken into account. Due to
the photosensitive elements of the receiver, it is
recommended to mount the receiver on the less
sunny side. Both the transmitter and the receiver
of the photocell should be mounted vertically,
the connection strips and the moisture drainage
holes in the cover should be in the lower part of
the housing. Proper alignment of the transmitter
and receiver is facilitated by the RX diode, which
lights up when the transmitter beam reaches the
receiver. Each of the housings is attached to the
mounting surface with 2 (diagonally mounted) or
4 screws included in the set.After installing the
photocells, remove the adhesive protective film
from the lampshades.
Do not install mirrors or reflective
screens in the photocell's area of
operation, the receiver should be
installed on the less sunny side, if
possible, the photocell receiver should not be
installed in a place exposed to a strong source
of extraneous light, especially from
fluorescent lamps, as this may interfere with
the barrier's operation. Be careful not to
contaminate the optical elements of the
transmitter / receiver during assembly.
Fig.1 Holes spacing in the scale of 1:1
with the assembly drawing.
Legend:
1. external splash-proof case
3. LED signal lamp module
2. holes for wires =6mm f
USE THIS FIGURE
AS TEMPLA
TE
126 mm
11 mm
20 mm
43 mm
10 mm
200
o
1
3
2