3
1) Registering remote control to receivers memory
2) Easy remote control registering
3) Simple remote control removing
4) Output (C1/C2) mode change to
or
.
5) Output (C1/C2) mode change to
bistable
momentary
monostable
Registering remote control do receivers memory is adding particular button with simulataneously assing recivers
output.
It is possible to assing few of buttons to the same channel or to assing remote control button to both of channels.
To remove programmed button, it is necessary to delete remote control from receiver's memory, and assing buttons in right
confriguration (point 3).
Button registering
(C1/C2)
Remarks!
C1/C2
Remarks!
Remarks!
Output's factory settings:
C1 output working mode
–
monostable (0,5s)
C2 output working mode
–
monostable (0,5s)
(C1/C2)
MOM
BIST
MONO
(C1/C2)
MONO
Remarks!
C1/C2
MONO
While pushing output button
push choosen remote control's button. LED diode will light.
If pushing output button
stops before pushing transmitter's button receiver will turn on output
programming mode. To exit push shortly other channel button.
It is possible to register new remote control without using receiver's buttons. New remote control must be in radio
range of receiver and previously registered remote control presence is necessary. Easy remote control registering is
unavailable if output is on momentary mode.
a) push and hold for 15 sec. any button of previously registered remote
b) within 3 sec. after releasing the previous button push and hold for 15 sec. any button of new remote control
c) new remote control is registered with same as previous remote configuration.
Failure in registering may be caused by radio interferences, low batteries or lock of easy remote registering
function.
To remove single remote control from receiver's memory push and hold simulataneously output buttons (C1 and
C2). All of LED diodes (except for green LED diode) will light. During lighting push any remote control's button that you want
to remove. Diodes will wane, remote will be removed from receiver's memory.
If you hold the receiver's C1 and C2 buttons for too long, receiver's memory will format.
For monostable mode check point 5.
To change mode of C1 or C2 output push and release chosen output button. Red LED diode will light
.
Yellow LED diode shows actual output mode. Push output button several times to set working mode. Yellow LED diode with
sing for momentary mode,
sing – bistable mode,
sing – monostable mode (check point 5.) To approve
chosen mode push and hold output button (C1/C2). Red LED diode will light and wane. Working mode is registered.
To change output mode to monostable push and release button
, red LED diode will light and yellow LED
diode which shows actual output mode will light. Push output button to set working mode on monostable, signalized by
yellow LED diode with
sing. To approve push and hold edited output button (C1/C2). LED diode with MONO sing will
fade, than start to blink. Hold output button for wanted turn on time in seconds. Number of blinking set turn on time in seconds
(or minutes if after releasing in short time button is being pushed for second again.)
To set turn on time 0,5s release
button before yellow diode with
sing light.
