DTM System miniR2 Series, Сборка и руководство по эксплуатации, Страница: 30 / 32

11. Setting the STOP / NO STOP function for the remote control button.
Using the radio control, the controller performs opening and closing in the sequence: open-stop-open or
close-stop-close.You can turn o
ff
the stop motion after pressing the remote control button again.
The function is available only for theOPEN andCLOSE remote buttons.
To setSTOP / NOSTOP mode:
Ÿ
press buttonsC1 andC2 of the controller simultaneously
Ÿ
release theC1 button
Ÿ
after 5 seconds, theSTOP andSBS LEDs will alternate light. Release theC2 button when:
LED on - sets the controller to stop mode after pressing the remote control button again, STOP
LED on - sets the controller in non-stop mode after pressing the remote control button again. SBS
Releasing the C2 button within 5 seconds of releasing the C1 button will exit the procedure
without saving the changes.
12. Formatting controller memory.
To format the controller memory, press and hold C1 and C2 buttons for 15 seconds. The LEDs will start to
fl
ash.The buttons should be released only when the diodes go out.
Formatting the memory:
Ÿ
removes all remotes from the controller,
Ÿ
disables remote adding function
Ÿ
removes theGalactic authentication code,
Ÿ
restores factory settings with an opening / closing time of 60 seconds..
Fig.11 Setting the STOP / NO STOP function.
1 PRESS AND HOLD C1 + C2
FOR 15 SECONDS
2
RELEASE C1 AND C2
WHEN LEDS GO OFF
- FORMAT SUCCESSFUL
15s
Fig.12
Formatting controller memory.
1
4
2
5
3
PRESS C1 + C2
RELEASE C2 WHEN
STOP ON - STOP MODE
RELEASE C1
RELEASE C2 WHEN
SBS ON - NO STOP MODE
STOP AND SBS LIGHT UP
EVERY 5 SECONDS
5s
EN