4. Locking / unlocking remote adding function.
To protect the device against unauthorized attempts to add an additional remote control, you must lock
the remote adding function.
In order to lock / unlock the remote adding function:
press buttonsC1 andC2 simultaneously,
then release the C2 button. After 5 seconds the OP and CL LEDs will start to blink alternately. Releasing
theC1 button when the light is on:
diode - remote adding function active
OP
diode - remote adding function is inactive
CL
Releasing the C1 button within 5 seconds of releasing the C2 button will exit the procedure
without saving the changes.
5. Entering the GALACTIC authentication code (only available for miniR2 868)
The GALACTIC function enables adding remotes programmed and con
fi
gured outside the installation,
without the need to use the controller buttons.
To enter the authentication code into the controller, it is necessary to have a remote control with the
GALACTIC function, with the authentication code set, entered by theGPROG programmer.
To enter the authentication code into the controller:
press buttonC1 to light theG diode
press and holdC1, release the button when theG LED starts
fl
ashing.TheG LED will
fl
ash for 8 seconds.
during this time, press and hold any two buttons on the remote control with the Galactic function for 5
seconds.TheG diode will blink three times indicating correct code entry.
The frequency of the G LED blinking indicates whether the authentication code is set.
Very fast blinking LED (10 blinks per second) informs about the lack of Galactic code in the
controller.
Slow blinking (1 blink per second) indicates the Galactic authentication code has been set.
Fig.7
Locking / unlocking remote adding function.
1
4
2
5
3
PRESS AND HOLD C1 AND C2
RELEASE C1 WHEN
OP LIGHTS
- LOCK OFF
RELEASE C2
OP AND CL BLINK
ALTERNATLY
EVERY 5 SECONDS
5s
RELEASE C1 WHEN
CL LIGHTS
- LOCK ON
EN