DTK PRM-92V, Руководство пользователя

Страница: 40 / 52

Chapter 4
34
device is. Otherwise the user should key in the mode of the device to the corresponding
field.
Some harddisks cannot work properly with its corresponding timing, please set a slower
timing.
Primary Master UDMA/Primary Slave UDMA/Secondary Master UDMA/Secondary
Slave UDMA: Available selections are Auto or Disabled. To choose Auto, the system BIOS
will scan the IDE device and decide Ultra DMA supported or not.
Init Display First: To select priority of initialization the PCI display card or the AGP display
card.
Onboard FDC Controller: Choose Enabled or Disabled. Enabled allows onboard Floppy
Drive Controller to be functioned, otherwise the users should use other sources.
Onboard Serial Port 1: Choose Auto, Disabled, 3F8/IRQ4, 2F8/IRQ3, 3E8/IRQ4 and
2E8/IRQ3. While choosing proper I/O Address/IRQ, be sure not to cause Address conflict
with other I/O devices. The default setting is Auto.
Onboard Serial Port 2: Choose Auto, Disabled, 3F8/IRQ4, 2F8/IRQ3, 3E8/IRQ4 and
2E8/IRQ3. While choosing proper I/O Address/IRQ, be sure not to cause Address conflict
with other I/O device. The default setting is Auto.
UART 2 Mode: Choose Standard, HPSIR or ASKIR (Amplitude Shift Keyed Infrared Port),
The default setting is Standard.
IR Function Duplex: Choose Half or Full.
TX,RX inverting enable: Choose No or Yes.
Onboard Parallel Mode: Choose Normal, EPP, ECP, ECP/EPP or Disabled.
Onboard Parallel Port: Choose None or with four different I/O Address and corresponding
IRQx. While choosing proper I/O Address, be sure not to cause Address conflict with other
I/O devices.
Parallel Port Mode: Choose SPP, EPP, ECP, ECP+EPP Mode. Make proper selection with
the attached printer port device.
ECP Mode Use DMA: Choose “1” or “3” to select the DMA channel used for the ECP
device. This item is shown if the Onboard Parallel Mode is chosen as “ECP” or
“ECP/EPP” option.
EPP Mode Select: Choose “EPP1.7” or “EPP1.9”, which is used to configure the EPP using
either EPP1.7 or 1.9 timing specification. This item is shown if the Parallel Mode is chosen