Chapter 5
46
DISK BOOT FAILURE, INSERT SYSTEM DISK AND PRESS ENTER:
No boot device was found. Insert a system disk into Drive A: and press <Enter>. If you
assumed the system would boot from hard drive, make sure the controller is inserted
correctly and all cables are properly attached. Also be sure the disk is formatted as a boot
device. Then reboot the system.
DISKETTE DRIVES OR TYPES MISMATCH ERROR - RUN SETUP:
Type of diskette drive installed in the system is different from the CMOS definition. Run
Setup to reconfigure the drive type correctly.
DISPLAY SWITCH IS SET INCORRECTLY:
Display switch on the motherboard can be set to either monochrome or color. This
indicates the switch is set to a different setting than indicated in Setup. Determine which
setting is correct, and then either turn off the system and change the jumper, or enter Setup
and change the VIDEO selection.
DISPLAY TYPE HAS CHANGE SINCE LAST BOOT:
Since last powering off the system, the display adapter has been changes. You must
configure the system for the new display type.
EISA Configuration Checksum Error
PLEASE RUN EISA CONFIGURATION UTILITY:
The EISA non-volatile RAM checksum is incorrect or cannot correctly read the EISA slot.
This can indicate either the EISA non-volatile memory has become corrupt or the slot has
configured incorrectly. Also be sure the card is installed firmly in the slot.
