DSPPA DSP9323, Руководство пользователя

Страница: 29 / 47

* *
SIP Intercom System
29
/
47
Hot Key Dial Mode
Select
<Primary /Secondary>mode allow system to call primary extension first, if
there were no answer, it would cancel the call and then call secondary
extension automatically.
<Day/Night>mode allow system to check the calling time is belong to Day or
Night time, and then decide to call the number 1 or number 2 automatically.
Users just press speed dial key once.
Call Switched Time
The period between hot key dialing to the first and second number. Initial Value
is 16 seconds.
Day Start Time The start time of the Day When you select<Day/Night>mode.
Day End Time The end time of the day When you select <Day/Night>mode.
Address of Open Log
Server
Log server address(IP or domain name)
Port of Open Log
Server
Log server port (0-65535) , Initial Value is 514.
Enable Open Log
Server
Enable or disable to connect with log server
Enable Indoor Open Enable or disable to use indoor switch to unlock the door.
Enable Card Reader Enable or disable card reader for RFID cards.
Limit Talk Duration If enabled, calls would be forced ended after talking time is up.
Door Unlock Indication
Indication tone for door unlocked. There are 3 type of tone: silent/short
beeps/long beeps.
Remote Code Check
Length
The remote access code length would be restricted with it. If the input access
code length is matched with it, system would check it immediately. Initial
Value is 4.
Block Out Settings
Add or Delete Blocked numbers – Enter the prefix of numbers which should not be dialed by the phone.
For example, if 001 is entered, the phone will not dial any numbers beginning with 001.
X and x are wildcards which match single digits. For example, if 4xxx or 4XXX is entered, the phone will
not dial any 4 digit numbers beginning with 4. It will dial numbers beginning with 4 which are longer or
shorter than 4 digits.
b) Audio
This page configures audio parameters such as voice codec, speak volume, mic volume and ringer
volume.