DSE RN-600C, Руководство пользователя, Страница: 77 / 80

USER MANUAL
Megapixel H.264 IP CAMERAS
Page: 77 Page: 77
DSE SRL - ITALY - WWW.DSE.EU
Restoring the factory settings
If you are not satisfied with the settings made or if detected irregularities in operation due to incorrect settings may be convenient to
restore the factory parameters of the camera. All cameras and video servers RN for this series are fitted with a reset button indicated by
RESET or DEFAULT.
If the button is not directly accessible from the outside there is a small hole inside which it is possible to insert a thin object, such as a
suitably deformed paperweight clips so as to press the reset button inside.
Some models, in waterproof, do not have a button accessible from the outside. In this case there is a DEFAULT terminal in the terminal
inputs and outputs. Instead of pressing the reset button will connect together the DEFAULT terminal with a GND terminal to start
precedura.
To restore the factory settings is not simply press the reset button, but you must scrupulously perform the following steps:
1. Disconnect the power supply of the camera and the outlet.
2. Insert a pin into the RESET hole and hold (in the models without the reset hole to short the DEFAULT and GND terminals)
3. Connect the power of the camera while continuing to press the button for a few seconds until the status LED flashes rapidly
..
4.
Releasing the reset button by removing the pin from the hole (in the models without the reset hole to remove the connection between the
DEFAULT and GND terminals)
5. Wait until the LED flash quickly and reconnect terms of the network
The camera has now returned to its factory settings.
CAUTION: Restoring the factory settings also includes access passwords, and network parameters.