DSC CFP-500, Руководство по установке

Страница: 8 / 32

6
Section 4: Programming the CFP-500
4.1 How to program
using the
CFP-550
Handheld
Programmer
4.1.1 Connect the CFP-550 to the Dialer
The CFP-550 connects to the dialer via the RJ-11 jack mounted on the dialer. An RJ-11 con-
nector cable is provided with the handheld programmer. Refer to the wiring diagram in “Con-
nect the CFP-500” on page 4 for the location of the RJ-11 jack.
Once the programmer is connected, it will power up and remain idle until programming is initiated.
4.1.2 Programming using the CFP-550
To program, follow these steps:
1. Press [*].
The programmer display will read “Enter Module Address.”
The dialer’s module address = 11.
The control panel address = 02
2. Enter [11] (for example).
The programmer display will read “Enter Installer Code” The default code = 2600.
3. Enter the installer’s code.
The display will read “Enter Section Number”
4. Enter a valid 3-digit programming section number to program that section.
5. Enter the programming data required by the selected programming section. Use the arrow
keys (< >) to view the programming data in the selected programming section.
To return to “Enter Module Address”, press [#] from the “Enter Section Number” display.
4.1.3 Entering Hexadecimal Digits
On occasion, hexadecimal (HEX) digits may be required. To program a HEX digit (A-F), press
the [*] key at any HEX data entry section. The panel will enter the HEX programming mode.
The following indicates which number should be pressed to enter the corresponding HEX digit:
1 = A 2 = B 3 = C 4 = D 5 = E 6 = F
If another HEX digit is required press the [*] key followed by the corresponding number entry.
After every HEX entry, the programmer will return to standard number entry.
4.1.4 Dialer Programming Section Descriptions
Telephone Numbers, Section [001]-[003] and [411] for DLS Phone Number
Telephone numbers can be up to 32 digits, allowing the addition of special digits, if required.
To program the telephone number, enter numbers 0 through 9 as required. Hexadecimal digits
(B-F) can also be used to perform the following functions:
HEX (B)-simulates the [*] key on a touch tone telephone
HEX (C)-simulates the [#] key on a touch tone telephone
HEX (D)-forces the panel to search for dial tone
HEX (E)-forces the panel to pause for 2 seconds
HEX (F)-end of telephone number marker
Three telephone numbers can be programmed. When programming, press the [#] key once
the telephone number is entered to exit the programming section.
Account Codes, Sections [011]-[012]
The account code identifies the panel to the central station when a communication is sent. Use
up to four digits for account codes.
When communicating events via the first or third telephone number, the first account code is
used. The second telephone number uses the second account code .
firealarmresources.com