6
Installing Cellular/Ethernet Communicator in
3G Alarm Communicator Installation Manual
d. Place the second nylon washer (flat), followed by the brass washer and the brass nut, onto
the threaded section of the cable,
outside
the panel. Tighten the assembly by hand only.
(Finger tight only- Do not overtighten the antenna assembly).
e. Locate the screw hole on the right side wall of the
bled Communicator with the right side wall of the
panel and, using the screw provided, secure the
mounting bracket to the panel.
f. Attach the other end of the PC-LINK cable to the
Communicator (black wire goes on Pin 1 of the
Communicator).
g. Using light pressure (finger tight only), attach the
supplied white quad band whip antenna to the
threaded antenna connection point at top of the
panel.
WARNING! - 3G2060/TL2603G/TL260 modules are
power limited. Do not route any wiring over the
circuit board. Maintain at least 1in. (25.4mm) sepa-
ration between circuit board and wiring. A mini-
mum of ¼ in. (7mm) separation must be
maintained at all points between non-power lim-
ited wiring and power limited wiring.
3. To electrically connect the Communicator to the panel, perform the following steps
(See
a. Disconnect both AC power and battery connections from the panel, and disconnect tele-
phone line.
Module Power Connection
b. Attach a wire from the Communicator’s left
PWR
terminal to the panel’s
BELL+
terminal.
c. Attach a wire from the Communicator’s
GND
terminal (beside PWR) to the panel’s
AUX -
terminal.
d. Attach a wire from the Communicator’s
SHLD
terminal to the panel’s
EGND
terminal.
(Protective earth ground).
(Optional) External Bell/Siren Connection
e. Attach a wire from the Communicator’s right
PWR
terminal to the positive (
+
) terminal on
the Bell/Siren.
f. Attach the panel’s
BELL
-
terminal to the negative (
-
) terminal on the Bell/Siren.
NOTE:
If an external Bell/Siren is not used, install the 1K
½W 5% resistor (Brown, Black, Red,
Gold) (supplied with the panel) between the panel’s Bell + and Bell - terminals, then only wire
the BELL + to the PWR terminal on the Communicator.
g. Confirm that the SIM card is inserted in the holder and locked.
DG009545
PC-Link
Cable Connector
(screw)
Quad band
Whip Antenna
PC1616/1832/1864
GSM Radio
RJ-45
U
A585
Use light pressure
to attach antenna
Finger Tight
only.
Figure 2:PC1616/1832/1864 Control Panel