Druck PACE1000, Инструкция по эксплуатации

Страница: 20 / 76

Copyright 2010 Baker Hughes Company.
10 | PACE Indicators Instruction Manual–English
Chapter 2. Installation
2.7 Power Connection
1. Before use, make sure the SELV power adaptor supplied with the instrument
is used.
2. Install an accessible power isolator to use as the disconnecting device in the
power adaptor supply circuit.
3. The power adaptor input power supply range: 100 - 240 VAC, 50 to 60 Hz,
600 - 300 mA, installation category II.
Note: The power adaptor must be supplied by a fused or overload-protected power
supply.
4. Connect the power adaptor to the instrument.
5. Switch the power supply on.
6. Check that the front panel display shows the power-up sequence. Refer to
Section 3.2, “Power-up Sequence,” on page 15.
Note: After the power-up sequence, the instrument shows the default display on the touch
screen. The touch screen divides into a number of mimic keys.
Requirements for rack-mounted and panel-mounted instruments
1. Install an accessible power isolator to use as the disconnecting device in the power adaptor
supply circuit.
2. Set the power supply isolator to OFF.
3. Connect the power adaptor before sliding the instrument into the rack.
4. Set the power supply isolator to ON.
5. Check that the front panel display shows the power-up sequence. Refer to Section
3.2,
“Power-up Sequence,” on page 15.
2.8 Communication Connection
Connect the applicable connectors into the rear panel communications ports. If appropriate,
secure with the captive screws.
Note:
The RS - 232 and IEEE 488 interfaces are both enabled at power-up. Set the required
parameters in Supervisor Setup/communications menu. Refer to Section 6.6.2,
“Communications,” on page 37.
WARNING
The ground lead of the instrument must be connected to the AC
supply protective safety ground.
Isolate the power supply before making any electrical connections to the rear
panel.
CAUTION
Use the power adaptor supplied with the instrument (Druck part
number IS1000118M9922-12). Using other power adaptors may cause over-
heating, this can result in a fire.
Do not let the power adaptor come into contact with any moisture or liquids.