Metro 80E
9
9
Metro 80E
Remove the 3 fastons (red, red and blue wire) from
the heating element (
Attention! This is an especially
fragile
component!
) and remove the 2 fastons from
the motor (blue and orange wire) (
situation O
);
Remove the entire heating unit (
13
) from the fi replace;
Remove both the effect glass sheet supports from the
fi
replace
(
8
and
9
);
Unscrew 4 parkers and remove the entire heating bed
profi
le
(
16
) from the fi replace (
situation P
);
Disconnect the 3 left fl at cables from the main PCB
(
situation Q
);
Disconnect the IR connector from the main PCB.
Press-in the lug fully to release the connector fully and
easily
(
situation R
);
Attention
: if the connector is pulled too hard, the hard
main PCB may be damaged irreparably.
Disconnect the 3-pole connector from the roll motor by
pressing in the lips of the cable harness section (
18
)
(
situation S
);
Remove the 3 parkers for removing the fl ame unit (
19
)
(
situation T
);
Situation N
Situation Q
Situation R
Situation S
Situation O
Situation P
INSTALLATION AND SERVICE MANUAL
Englisch
463385-D84-03-NL.indd Sec1:9
463385-D84-03-NL.indd Sec1:9
07-12-2007 11:09:36
07-12-2007 11:09:36
