Dru Maestro 60/2 Tall RCH, Руководство по установке

Страница: 46 / 68

I nst allation manual
4 6
Eco Glow appliances have a different type of base covering to appliances without Eco Glow.
3
- The vermiculite plates are provided with square holes, which ensure air supply. Do not place more than one layer of
base covering over these holes.
- Ensure that the base covering does not enter the slot for the glass pane.
1
For appliances without Eco Glow , use all chips in the wood set.
1
Fill the vermiculite plates with chips, spread the chips evenly, keep the sections marked in red free of chips (see fig. 8-17).
1
For appliances with Eco Glow , use the Glowing Embers, coals and a portion of the chips as indicated in the woodset.
2
First place the Glowing Embers and then the coals. Switch on the glow lighting while placing, so that the stray light can
be seen directly and covered with the rocks and coals.
1
Spread the Glowing Embers over the grid pattern and square holes in the vermiculite plate, keep the sections marked in
red free (see fig. 8-18).
1
Spread the chips over the remaining sections, keep the sections marked in red free.
1
Identify logs A to G (see fig. 8-9).
2
Use the burn marks on the logs for identification.
1
Place log A on the positioning lugs (see fig. 8-19).
1
Place log B parallel to the burner on the front two positioning lugs. The rear side must be parallel with the rear
positioning lug.
1
Place log C with the slot above the positioning bracket and allow the groove at the rear to slide over the positioning lug.
1
Place log D to the rear of log C (see fig. 8-20).
1
Place log E with the rear side in the positioning lug and place the front side in the groove of log E. There must be a gap of
at least 1 cm between the right burner and log E.
1
Place log F above the left burner. The log must fully rest on the burner and must not be supported by the base covering
(see fig. 8-21).
1
Place log G above the right burner. The log must fully rest on the burner and must not be supported by the base
covering.
1
Eco Glow appliances have a different type of base covering (see fig. 8-22).
1
Spread the ash, if desired, over the base covering, ensure that it does not cover the burners.
1
Reinstall the glass pane (see section 8.3).