Dru Maestro 60/2 Tall RCH, Руководство по установке

Страница: 34 / 68

I nst allation manual
3 4
3
When placing the chimney breast, you should take the following into account:
- The minimum dimensions of the chimney breast surround (see fig. 7-13).
- In case of the minimum width dimension, a centred placement of the appliance is presumed in order to guarantee
sufficient convection (see fig. 7-13).
- The location of the control hatch: this must be placed as low as possible.
- The distance of the control hatch up to the side of the appliance (see fig. 7-14).
- The dimensions of the control hatch (see section 7.5).
- The location of the ventilation holes (V-out).
- A minimum 100 mm distance between the top of the ventilation hole (outgoing) and the ceiling of the room.
- The dimensions of the glass pane, so that it can be placed/removed after placing the chimney breast.
- Protection of components and pipes of the appliance control unit against building dust such as cement and lime.
- Placement of decorative strips, frames and such like; if possible, install these after the carrying out any structural work.
If this is not possible, protect them during this work. Avoid the use of painter's tape. If this is not possible: use good
quality painter's tape and remove this tape immediately after plastering or painting work (prolonged application of
painter's tape may cause damage).
3
You should preferably apply the ventilation holes (outgoing) on both sides of the chimney breast. Use the DRU
ventilation elements.
Check the following items, before the chimney breast is fully closed:
- Is the discharge / concentric system placed correctly?
- Have the channels, fastening brackets and possible clip bindings, that become inaccessible later, been secured with
self-tapping screws?
- Has no plastering work been performed on or across the edges of the construction frame? This due to the fact that:
- the heat of the appliance could cause cracks;
- It will no longer be possible to remove/place the glass pane.
- When using stone-like materials and or plaster finishing, allow the chimney breast to dry for at least six weeks prior to
taking the appliance into operation in order to prevent cracks.
38C-2620
≥500
≥ 120
≥700
≥ 120
≥ 120
7-12